7050 Laser CO2 90W

1) 700x500mm working area with honeycomb table
2) Ruida 6442x
3) Laser tube 90W
4) Auto Focus
5) High Pressure Air Compressor 005
6) Connection for rotating device
7) water pump
8) Good quality lenses and mirrors - focusing lens diameter
20 mm, mirror diameter 25 mm
9) Big 57 engine
10) Lid protection sensor
11) Water flow sensor

Rotary - Rubber Wheels Type

Installations- und Reisekosten ausgeschlossen

Extension tube for using the feed-through slot on machines with short lens tube/nozzle (Diam.18mm).

115/230V MYJG CO2 Power Supply

Features
1. Zero-current half-bridge soft-switching circuit. High efficiency and fast response. Match various manufacturers of laser tubes.
2. Simple Port Control, TTL level signals can control the laser start / stop.
3. Protection switch to check the outside water, ventilation, etc.
4. Laser Power Adjustment: input OV to 5V analog Signal, can also input PWM Signal.
5. Open Circuit Protection Function: avoid the damage to laser power supply due to laser tube burst.
6. Factory Aging Test: A. Each power supply will go through 600°C and 12 hours aging test under full Ioad. B. 500 times 7 seconds Start / Stop test.

Exhaust purification, multi-layer filter unit.

Precise alignment through image capture (camera)!

Exhaust purification, multi-layer filter unit.

7050-Pro CO2 Laser 90W - New Model!

1) 700x500mm working area with honeycomb and blades (Double Working bed)
2) Ruida 6445x
3) 90W laser tube (optional up to 120W) (RECI, YongLi)
4) Auto Focus
5) Electric Z axis controlled by RD6445x
6) 008 high pressure air compressor
7) Connection for rotating device with extra embedded driver
8) CW3000 included
9) High quality lenses and mirrors - II-VI import from USA, focusing lens diameter 20mm, mirror diameter 25mm
10) Big Stepper motors Nema57 (1.2° Resolution)
11) Cover protection sensor
12) Z-axis up/bottom sensors
13) Water flow sensor

Permanent CO2 Laser Marking
500ml Spray can

Creates a solid, permanent charcoal mark when laser engraved on glass or ceramic

Permanent CO2 Laser Marking
500ml Spray can

Creates a solid laser engraving on uncoated stainless steel

1390 CO2 Laser 110W - New Model!

1) 1300x900mm working area with honeycomb and blades (Double Working bed)
2) Ruida 6445x
3) 110W laser tube (RECI, YongLi, SPT) (optional up to 300W)
4) Auto Focus
5) Electric Z axis controlled by RD6445x
6) 008 high pressure air compressor
7) Connection for rotating device with extra embedded driver
8) CW3000 included
9) High quality lenses and mirrors - II-VI import from USA, focusing lens diameter 20mm, mirror diameter 25mm
10) Big Stepper motors Nema57 (1.2° Resolution)
11) Cover protection sensor
12) Z-axis up/bottom sensors
13) Water flow sensor
Robust Construction, ideal for laser engraving and precise cutting.